Quite awhile ago, Sofie and I bought some quilting cottons in green and pink to decorate her room. First project was to make an upholstered headboard. After much research (thank God for the Internet) we decided to have a go.
First, Sofie decided on a design. Then we traced a curve on some Burda tracing paper. From there we traced onto the board. We recycled an old desk we had in our previous house but have no use for in the new one.
Next job was to cut out the shape with the jigsaw.
We took the paper template to Clarke Rubber and have them cut out some low density foam (about 4cm thick) to fit the bed head. They also sold wadding which saved us a trip to the fabric store.
The foam was glued to the board and the wadding wrapped around and stapled down. The fabric was then stapled being careful to make sure it was nice and lined up.
We used "hooks and eyes" to attached the head to the wall. More scary power tools! We put the eye pieces on the wall and put the hooks into the back of the head. Here you can see the back is not so pretty, but hopefully this side will never be seen.
Et voila!
All styled up. Next project will be a duvet cover and some matching pillow slips I think. We also plan to recover a stool and make a runner for her chest of drawers.
Unfortunately the fabric was not wide enough and I had to seam pieces on the sides. This was the most time consuming part of the whole project. To make sure that the pattern matched up I used Summerset's way of basting from the front before machine stitching from the back. Works like a charm - can't see the seam can you?
From this angle you can see the width of the head board. Also you can see that the messy back can't be seen.
Not bad, if I do say so myself!